Intermec IF2 Manuel d'utilisateur télécharger pdf (Page 75)

Chapter 4 — Managing, Troubleshooting, and Upgrading the IF2

IF2 Network Reader User’s Manual 65

To connect directly to the IF2 RFID module and verify operation

1 Make sure the RFID antenna is connected properly to the IF2.

2 Apply power to the IF2.

3 Use a communications program (such as HyperTerminal) to open

a TCP/IP connection to the IF2 with these parameters:

Configure the communications program to echo typed characters

locally and to send line feeds with line ends.

4 Press Enter. The BRI prompt (OK>) appears.

If the prompt does not appear, there may be a problem with the

RFID module or your connection to the module.

5 Type ATTRIB and press Enter. A list of the current settings for the

RFID module appears, indicating that the module is receiving

commands.

If the list does not appear, there may be a problem with the RFID

module.

6 (Optional) To verify that the RFID module is reading tags:

a Place a known good RFID tag within range of the antenna.

Parameter Value

IP Address IP address of the IF2

Port 2189

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 103 104

Pas de commentaire

Intermec IF2 Manuel d'utilisateur Page 75