Intermec EASYCODER PL4 Manuel d'utilisateur télécharger pdf (Page 36)

36 EasyCoder PL4 Printer User’s Guide

! U1 SETVAR “ip.gateway” “xxx.xxx.xxx.xxx”

! U1 SETVAR “ip.addr” “xxx.xxx.xxx.xxx”

where “xxx.xxx.xxx.xxx” will be replaced with valid values for

your network. If you are unsure what values to enter, please

contact your network administrator for assistance.

6 Turn the printer off and on.

7 Test the configuration. For help, see the next procedure.

To test that the printer is ready for LPD or TCP printing

1 Print a configuration label. For help, see “Verifying the

Printer Is Working” earlier in this guide.

2 Ping the IP address of the printer and verify

acknowledgement (from a DOS prompt on Windows

platforms).

3 Print a test label via Intermec PLUS. Test using TCP sockets

(port 6101) and LPD.

Setting Up WEP Encryption

PL4 printer

Access

point

Host

Laptop

PL4U051.e

Before setting up the printer, you need to know the WEP key

that your wireless network is using. If 40-bit encryption is

enabled, the key is 10 hexadecimal (0 to 9, A to F) characters;

otherwise, if 128-bit encryption is enabled, the key is 26

hexadecimal characters.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 64 65

Pas de commentaire

Intermec EASYCODER PL4 Manuel d'utilisateur Page 36