Intermec PF2i Manuel d'utilisateur télécharger pdf (Page 61)

Chapter 2 — Connecting the Printer

PF2i and PF4i Mid-Range Printer User’s Manual 47

2 Send the following commands to permanently assign the IP

address, subnet mask, default router, and name server:

<SI>nn[,m1[,m2]]

where:

n is the IP address of the printer in the format n.n.n.n, where n is a

number from 0 to 255.

,m1 is the subnet mask address in the format n.n.n.n, where n is a

number from 0 to 255.

,m2 is the router address in the format n.n.n.n, where n is a

number from 0 to 255.

3 Disconnect the printer from the PC.

4 On your PC, enter the IP address of the printer in the address field

of your web browser (for example http://10.200.27.94) and press

Enter.

The home page of the printer appears.

Setting Up 802.11 Radio Communications

If your printer has an optional 802.11 b/g radio, you can transfer and

receive data using wireless communications. This manual assumes

that you have already set up your wireless communications network

including your access points. This section describes how to set up

wireless security on your printer.

The printer supports these authentication modes:

• none

• WEP (64 bit and 128 bit)

• WPA Personal and Enterprise mode (802.1x authentication)

• WPA2 Personal and Enterprise mode (802.1x authentication)

Note: You must specify at least two of the three parameters for the

command to take effect.

Note: WPA and WPA2 Enterprise mode currently support PEAP,

TTLS, LEAP, and EAP-FAST. For LEAP authentication, the printer

supports Open EAP, but does not support Network EAP.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 193 194

Pas de commentaire

Intermec PF2i Manuel d'utilisateur Page 61