Intermec EASYCODER PD4 Manuel d'utilisateur télécharger pdf (Page 59)

100

Intermec EasyCoder PD4—User’s Guide 49

Chapter 7—Troubleshooting

Clearing Media Jam in Cutter

To clear a media jam inside the cutter mechanism, follow the instructions

below:

1 At media jams and cutter malfunctions, switch oﬀ the power to the

printer.

Never insert ﬁngers or tools into the printer while the

power is still on.

2 Insert a 3 mm hexagon screwdriver in the hole on the side of the

cutter (A) and turn the cutter blade clockwise.

3 After the media jam is cleared, switch on the power to the printer, and

the cutter blade will go back to its original position.

Note: It is recommended to use labels with a length of 30 mm

(1.18 in) or more.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 99 100

User’s Guide 1
EasyCoder PD4 1
Bar Code Label 1
Contents 5
Technical Data 7
Media Speciﬁcations 7
Interfaces 7
Firmware Upgrading 7
Before You Begin 8
Safety Icons 9
Global Services and Support 10
Introduction 11
Description of EasyCoder PD4 12
Safety Warnings 13
Product Identiﬁcation 13
Chapter 1—Introduction 14
Installation 15
Unpacking the Printer 16
Front View 17
Rear View 18
Media Compartment 19
Print Mechanism 20
Connections 21
Controls and Indicators 22
Key Functions 23
Chapter 2—Installation 24
Starting Up 25
Switching On the Printer 26
Direct Mode 27
Printing a Test Label 28
Loading Media 29
Tear-Oﬀ (Straight-through) 30
Tear-Oﬀ, cont 31
Peel-Oﬀ (Self-strip) 35
Peel-Oﬀ, cont 36
Thermal Transfer Printing 39
Ribbon Load 40
Ribbon Load, cont 41
Chapter 4— Loading Media 42
Printing 43
Controlling the Printing 44
Setup Methods 45
Navigating in the Setup Mode 45
46
Chapter 5—Printing 48
Installation Instructions 50
Chapter 6—Options 51
Rewinder cable 51
Troubleshooting 55
Error Handling 56
Clearing Media Jam in Cutter 59
Entering the Dump Mode 60
Maintaining the Printer 61
Printhead Cleaning 62
Clean the printhead dot line 63
External Cleaning 64
Printhead Replacement 65
Media Jams 66
Adjustments 67
Printhead Balance Adjustment 68
Printhead Pressure Adjustment 69
Chapter 9—Adjustments 70
Point of 72
Sensor lever 72
Label Gap Sensor Calibration 73
Ribbon Tension Adjustment 74
1234567890 75
Switching Edge Guide 76
Table of Technical Data 80
Media Roll Size 84
Non-Adhesive Strip 85
Self-Adhesive Strip 86
Self-Adhesive Labels 87
SELF-ADHESIVE 88
DIRECTION 88
Tickets with Gaps 89
TICKETS & TAGS 90
Tickets with Black Mark 91
TICKETS 92
WITH MARKS 92
RS-232 Interface 94
USB Interface 95
Parallel Interface 96
Requirements 98
Instructions 98
*1-960614-01* 100

Commentaires sur ces manuels

Pas de commentaire

Intermec EASYCODER PD4 Manuel d'utilisateur Page 59

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimantes d'étiquettes Intermec EASYCODER PD4