Intermec EASYCODER PD4 Manuel d'utilisateur télécharger pdf (Page 60)

50 Intermec EasyCoder PD4—User’s Guide

Chapter 7—Troubleshooting

Entering the Dump Mode

In the Dump Mode, the printer prints all received ASCII characters

including control characters (ASCII 00-31 decimal). ere is automatic

line-wrapping and if a label becomes completely ﬁlled, the dump contin

ues on a new label. is facility is useful for debugging.

Enter the Dump Mode like this:

1 Switch oﬀ the power to the printer.

2 Press and hold the Feed key while you switch on the power again.

3 e Feed key must be pressed for more than 2 seconds after power up

(else a test label will be printed).

4 When the printer is in Dump Mode, this message will be displayed

provided the printer is ﬁtted with an optional display:

In the Dump Mode, you can reset the printer to its default setup values

by pressing the Cancel key for 3 seconds or more.

To exit the Dump Mode and enter the Direct Mode, tap the Feed key.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 99 100

Pas de commentaire

Intermec EASYCODER PD4 Manuel d'utilisateur Page 60