Intermec 073290-001 Fiche technique télécharger pdf (Page 20)

Chapter 2 — Replacing Parts

5 Remove the scanner or imager flex cable from the main PCB.

6 Disconnect the trigger reed switch cable from J4 on the main PCB. The

top and bottom covers are now separated.

Trigger reed

switch cable

Scanner

or imager fle

cable

7 Lay both covers down so that the exterior sides face down.

Replacing the 802.11b/g Radio and Antenna

To replace the radio and antenna, you need the following tools and parts:

• T10 Torx screwdriver

• Small Phillips screwdriver

• Antenna cable remover (P/N 591802-001)

• 2.4 GHz single feed antenna assembly (P/N 073360S-003)

• Mini PCI radio assembly (P/N 073155-001)

• 2-56 x 3/16 stainless steel screw (P/N 801-210-000)

• 2-28 x .250 Plastite flathead screw (P/N 800-193-000)

• 2-56 x 5/32 stainless steel screw (P/N 801-209-001)

To replace the 802.11b/g radio or antenna

1 Open the CK30. For help, see the previous procedure.

2 Remove the two Phillips screws from the top of the antenna assembly and

remove the antenna ground plane.

3 Remove the four Phillips screws (two self-tapping flathead and two machine)

from the mini PCI shield assembly and lift the shield off of the radio

assembly.

10 CK30 Handheld Computer Service Manual

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 112 113

Pas de commentaire

Intermec 073290-001 Fiche technique Page 20