Intermec 073290-001 Fiche technique télécharger pdf (Page 30)

Chapter 2 — Replacing Parts

8 Insert the new display assembly into the top cover.

9 Attach the display flex cable and the keypad flex cable to the main PCB.

10 Replace the main PCB and secure it with the two Phillips screws

removed in Step 3.

11 Connect the power indicator/good read light pipe assembly cable and

the speaker PCB cable to the main PCB.

12 Close the CK30. For help, see “Closing the CK30” on page 27.

Replacing the Keypad Assembly

To replace the keypad assembly, you need the following tools:

• T10 Torx screwdriver

• Small Phillips screwdriver

You also need one of the following parts depending on the CK30

configuration:

• CK30 42-key keypad assembly (P/N 072857-002)

• CK30 50-key keypad assembly (P/N 072858-003)

• CK30 52-key keypad assembly (P/N 072859-002)

• Keypad flex cable (P/N 073094-001)

• KA22 x 6 WN 1412 Elco screw (591825-001)

To replace the keypad assembly

1 Remove the bezel assembly. For help, see “Replacing the Bezel

Assembly” on page 17.

2 Pry up one corner of the keypad assembly and carefully lift it away from

the top cover being careful not to detach or damage the keypad flex

cable.

Keypad

assembly

3 Disconnect the keypad flex cable from the keypad assembly.

20 CK30 Handheld Computer Service Manual

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 112 113

Pas de commentaire

Intermec 073290-001 Fiche technique Page 30