Intermec SF61B 1D Guide de l'utilisateur télécharger pdf (Page 42)

Chapter 2 — Connect the SF61B

30 SF61 Cordless Scanner User’s Guide

Connect the SF61B to an Intermec SD62 Base

Station

You can connect up to seven Intermec Bluetooth scanners to the

SD62 Base Station.

To connect up to 7 scanners

1 Connect the SD62 base station to a host device using the correct

cable for your interface.

See the SD62 Base Station User’s Guide available on the Intermec web

site at www.intermec.com for details on how to connect your

SD62.

2 With each scanner you want to connect, scan the Bluetooth

System Connect bar code label on the SD62 base station and wait

for the connection to be established.

The scanner beeps twice, the green status light flashes twice and

the blue Intermec Ready-to-Work indicator starts blinking (may

blink for a few seconds). When the scanner connects to the base

station it emits a series of beeps from low to high. The blue

Intermec Ready-to-Work indicator turns on and stays on for both

the scanner and base station.

Disconnect the SF61B from an SD62 Base Station

To disconnect your SF61B from the SD62 base station

1 Read the Bluetooth Device Disconnect bar code.

Bluetooth Device Disconnect

The SF61B emits the “disconnect successful” beep sequence (series

of beeps from high to low) and the SF61B’s Intermec Ready-to-

Work indicator goes off.

Note: If you are connecting the SR61B to the SD62 base station use

the SD62 Base Station User’s Guide and the SD62 system command file

in EasySet for connections and setup.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 103 104

Pas de commentaire

Intermec SF61B 1D Guide de l'utilisateur Page 42