Intermec SF61B 1D Guide de l'utilisateur télécharger pdf (Page 51)

Chapter 2 — Connect the SF61B

SF61 Cordless Scanner User’s Guide 39

If a pairing code or validation is requested, click Enter the

device’s pairing code (or the equivalent command) and enter the

scanner’s pairing code (the default Intermec Bluetooth pairing

code is “0000”)

6 Start the host application you want to connect to and open the

Incoming COM port you noted previously.

When the scanner connects to your host application, it emits a

series of beeps from low to high, and the blue Intermec Ready-to-

Work indicator turns solid blue (default scanner behavior).

Test Your SPP Incoming Connection With the Host

Read the following test code and check that it is correctly displayed by

the host application to make sure that your connection is working

correctly:

Code 39 Test Bar Code

*123456*

To Disconnect From the Host

Use the Bluetooth disconnect procedure specific to your host

application to close the Incoming COM port.

When the scanner disconnects from the host PC, it emits a

“disconnect successful” beep sequence (series of beeps from high to

low), and the blue Intermec Ready-to-Work indicator blinks slowly for

5 minutes to indicate it is waiting to connect (default scanner

behavior).

When you open the Incoming COM port again, if the scanner is

switched on it will reconnect to the host application.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

Pas de commentaire

Intermec SF61B 1D Guide de l'utilisateur Page 51