Intermec EASYCODER PD4 Manuel d'utilisateur télécharger pdf (Page 54)

44 Intermec EasyCoder PD4—User’s Guide

Chapter 6—Options

5 Attach the cutter cover onto the cutter mechanism by ﬁrst connecting

the hooks on the back side of the cover over the cutter mechanism and

then locking the cover with the screw at the bottom.

6 If needed, ﬁt the tray to the front of the cutter.

7 Install the media as described in Chapter 4 “Media Load”, section

“Tear-oﬀ (Straight-through)”. Recommended label/paper length is at

least 30 mm (1.18 in).

Note: Make sure that the printer is set to use the cutter, either

in the Setup Mode (see Chapter 7) or using an O command,

see ESim v5.xx for EasyCoder PD4, Programmer’s Reference

Manual. e label taken sensor cannot be used with the cutter.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 99 100

Pas de commentaire

Intermec EASYCODER PD4 Manuel d'utilisateur Page 54